Construction sites change every day. Routes run over formwork panels, steel plates or loose boards. Rain, mud, frost and construction dust quickly make these surfaces slippery. A well-thought-out anti-slip concept for the construction site ensures that workers and visitors have a safe footing even on temporary traffic routes.
Trips, slips and falls are among the most common workplace accidents. On construction sites, changing surfaces, differences in level and bad weather are added to the mix. Antirutschprofi offers mats, tapes, profiles and coverings that can be deployed quickly and relocated as construction progresses. We will advise you on the right combination for your project.
Typical hazard points on construction sites
- Temporary walkways over soil, gravel or formwork panels
- Temporary site stairs made of timber or steel, especially at the step edges
- Scaffold decks, platforms and transitions between scaffold levels
- Steel plates and covers over trenches and openings
- Access to containers, site offices and sanitary facilities
- Cables and hoses running across walkways
- Ladders and fixed ladders whose rungs become slippery when wet or dirty
Suitable anti-slip solutions for construction sites
Slip-resistant mats for site walkways
Construction site and walkway mats on the roll can be laid on uneven ground and relocated as required. The profiled surface provides grip in wet and muddy conditions. A conspicuous colour additionally marks the route. This creates temporary non-slip walkways on the construction site without permanently altering the ground. Find out more under Anti-slip mats.
Robust mats for outdoor areas
For heavily used access points, for example in front of site containers or at material stores, heavy outdoor mats are suitable. They are designed for the weather and allow water to drain away. Versions with corresponding test certificates for slip resistance are available on request. Details can be found under Outdoor anti-slip mat.
Slip protection for temporary site stairs
Step edges are the critical point of every site staircase. Self-adhesive anti-slip strips increase the grip of the tread surface. For heavily loaded timber and steel steps, screw-on profiles are also an option. You will find suitable products under Anti-slip strips and Stair nosings.
Anti-slip covering for scaffold areas
On scaffold decks, platforms and transitions, a thin covering with good adhesion is essential. Anti-slip tapes can be cut to size and applied specifically to walking surfaces. Check whether the covering and fixing are compatible with the scaffold system. If you have questions about approval, contact the scaffold manufacturer.
Cable mats for walkways
Power cables and water hoses are unavoidable on construction sites. A non-slip cable mat covers them and reduces the risk of tripping on walkways. At the same time, it protects the cables and hoses from damage.
Ladder rungs and climbing routes
Dirty rungs are a common cause of falls from height. Ladder rung covers improve grip on ladders and fixed ladders. They are fitted over existing rungs.
Selection: what matters
slip resistance ASR A1.5 “Floors” (German Technical Rule for Workplaces) and its Annex 2 serve as guidance for the required slip resistance rating. Outdoors and where slippery substances such as mud are present, higher ratings are usual. The specific requirement follows from your risk assessment.
Substrate: Loose mats are suitable for soil, gravel and frequently changing routes. Tapes and strips need a load-bearing, clean and dry substrate. The suitable products differ for timber and steel.
Cleaning: Construction dirt quickly gets lodged in profiles. Look for surfaces that can be cleaned with water or a broom. Regular inspection is part of keeping traffic routes safe.
Fixing: Loose laying is flexible but can shift. Screwed or bonded solutions hold permanently but are more laborious to relocate. Consider how often the route layout changes during construction.
How your enquiry works
- You tell us about the areas of use, substrates and approximate areas or lengths, ideally with photos.
- We check the requirements and suggest suitable products and versions.
- You receive a quote and can decide on the scope and version at your leisure.
Suitable products
A selection from our range. We will be happy to provide sizes, versions, prices and delivery times on request.
Ribbed mat Walk
Item no. DD-FM-WALK
Fine or broad ribbed matting as rolls or cut to size for vehicle fit-outs, tool trolleys, workbenches, drawers and packing tables; WALK EXTRA is oil-resistant.
- 3 or 4 mm, roll 10 x 1 m (XL: 1.20 m)
- Fine or broad ribs
- oil-resistant version with 25% NBR
Coarse anti-slip tape, black/yellow
Item no. DD-GRP-3000087-BY
Coarse-grit anti-slip tape for heavily used steps, platforms and surfaces. The black/yellow version also serves as a warning marking.
- Rolls 25/50/100 mm x 18 m
- Can be cut to size
- Non-conductive
Rubber ring mat Octoroll on the roll
Item no. DD-CB-RM010014
Rubber ring matting by the metre for large or unusually shaped entrance areas. Open holes let rainwater and dirt drain away, and the surface pattern scrapes shoe soles clean. Can be loose-laid, indoors and outdoors.
- Roll 1.0 x 9.3 m or by the running metre, 13 mm
- High recycled content
- Drainage holes, UV-resistant
Cable protector CablePro HD
Item no. DD-CB-CP010001
Heavy-duty PVC cable protector with access ramps for areas with vehicle and forklift traffic. Channels for thick cables and a pre-slit back make inserting cables easier; suitable for indoor and outdoor use.
- Load capacity up to 1500 kg
- 23 mm cable channels
- Ramped edges, loose-laid
Ground protection mat COBATrack (HDPE)
Item no. DD-CB-TT010001
Reusable ground protection mat made of recycled HDPE for temporary roadways on construction sites, events and parking areas. Traction profile on one side, ribbed texture on the other; can be connected using PU or steel connectors.
- High load capacity according to the manufacturer (heavy traffic)
- 915 mm x 2.4 m, 10 mm, 20 kg
- Integrated carrying handles and connection holes
Floor protection film COBAguard
Item no. DD-CB-CGH00006
Self-adhesive PE protective film for temporarily covering hard floors and carpets during renovation, fit-out and maintenance. Peels off without residue; can be laid by hand or with an applicator.
- Versions for hard floors and carpet
- Rolls 0.6/1.2 m x 25–100 m
- Leaves no residue
Frequently asked questions about anti-slip on construction sites
How can temporary non-slip walkways be set up on a construction site?
The easiest way is with walkway mats on the roll. They are laid out, secured if necessary and relocated when the route changes. On firm ground, anti-slip strips can also be used.
Which slip-resistant mats are suitable for site walkways?
Weather-resistant mats with a profiled surface that allow water to drain away are suitable. For heavily loaded areas, heavier versions are an option. We will advise you based on your substrate.
How can temporary site stairs be given slip protection?
Self-adhesive anti-slip strips on the treads and stair nosings on the step edges have proven effective. For steel stairs with chequer plate or grating there are dedicated solutions.
Which anti-slip covering is suitable for scaffold areas?
Usually thin anti-slip tapes or coverings that can be cut to size and applied to the walking surfaces. Clarify compatibility with the scaffold system with the manufacturer in advance.
Safe routes are the basis for smooth operations on every construction site. Tell us about your project. We will put together a suitable selection of anti-slip solutions for your construction site.